Razor Coil Fencing
How to install razor coil wire fence in under 10 steps:
Safety first. Before any handling or installing of the concertina rolls, always use work gloves to protect your hands.
Gloves with reinforced palms are ideal to help protect your hands when catching the concertina wire.
STEP 1: Determine the number of coil rolls used in each stage or section of fencing.
STEP 2: Place on rolls of razor wire fence, holding the initial post at the bottom and top.
STEP 3: After placing the roll on the pole razor wire where to install, it is necessary to set the upper and lower pole clamp.
STEP 4: Once the razor wire subject to the post, the next step will tighten the upper wire and that these remain positioned horizontally and parallel to the base of the fence, using the wire tensioner. Once done, then repeat with the remaining wires.
STEP 5: Once tensioned wires, and using these as clamping the razor wire, you must distribute rolls at a distance of 6 to 10 meters apart
STEP 6: Distributed razor wire rolls, hold the tip beginning of the roll between the clamp and the barbed wire.
STEP 7: Distribute the razor wire every 25 cm, once a roll has come to an end, you must hold the tail end of the first roll with the point of beginning of the second, so that there is no space of perimeter uncovered, this is important, because it can be an easy point of exceeding our fence and our installation will not be helped.
STEP 8: With razor wire rolls distributed along the fence.
To be absolutely still and no movement is occurring, we hold the fence around every 3 spiral.
This step is recommended to use galvanized wire, as it is more manageable and durability is much higher.
After these 8 simple steps we have installed our razor wire fencing.
The steps may sound easy however it requires a decent amount of knowledge and expertise. With this being said, at affordable rates and convenience contact Amita Fencing for your requirements on razor coil fencing in Johannesburg.